Filter
Top Products
107
Transmitting Files When you transmit a file, screen data, memory table data, and mark data
registered in the PT is completely overwritten unless the resume operation is
set to ON. If the resume operation is ON, memory table data will not be
changed.
Note When using EEPROM, the PT memory must be initialized (i.e., cleared) in
advance from the maintenance menu to transfer data to the PT’s image data
memory.
1, 2, 3...
1. Go to the File Selection Display.
2. Move the bar cursor to the file you want to transmit, and then press F6
(Transmit). A message will appear asking whether you actually want to
transmit the file.
3. If you do want to transmit it, press the Enter Key.
To return to the File Selection Display, press any key other than the En-
ter Key.
4. Select whether or not you want to confirm transmission. Select “Yes” or
“No,” and then press the Enter Key. Transfer will begin.
5. To return to the File Selection Display, press the Escape Key.
Transmitting Data Section 6-2