Filter
Top Products
34
Number of integer
digits (Integer)
Set the number of digits for the integer portion of the
number.
Number of decimal
digits (Decimal)
Set the number of digits for the decimal portion of the
number.
Zero suppress (Zero
Sup)
Set whether or not leading zeros are to be displayed on
the screen.
Display sign (Disp
Sign)
Set whether or not negative signs are to be displayed on
the screen. The positive sign is not displayed.
Character size (Char
Size)
Set the size of characters to be displayed on the screen.
Scale Set the scale factor for the display. The NT600M can be
set to 64X in addition to those shown above.
Attributes Sets display attributes for the screen. Refer to page 24
for examples of how attributes are displayed on screen.
Display type (Disp
Type)
Specify either decimal or hexadecimal display.
Press the Enter Key after completing all of these settings.
8. Set the display position. When the display position has been set, you
can return to set another numeral display or you can continue pressing
the Escape Key to return to the Initial Edit Display.
Deleting and Modifying Direct connection numeral displays are deleted or modified from the display
shown in step 1. above. Select the number of the numeral table and then
specify DELETE or MODIFY. The modification procedure is basically the
same as the creation procedure given above.
2-3 Character String Displays
The contents of character string tables can be displayed on the screen. The
string table entry to be referenced, the display position, and manner of dis-
play must be set.
You can set a maximum of 8 string displays per screen for the NT20M and 50
for the NT600M.For the NT20M, string table entries are numbered from 0 to
31, for a total of 32. For the NT600M, string table entries are numbered from
0 to 255, for a total of 256.
The procedure for setting number displays depends on whether or not direct
connection is ON or OFF in the Tool Settings. Both procedures are given be-
low.
Character String Displays Section 2-3