Filter
Top Products
32
Recording
Hints for Timer Recording
Note for DVD recording
PROG. A
PROG. B
Actual
recording
The first 30 seconds (at the longest) will be cut off.
PROG. BPROG. A
When the End time of the programming
currently being recorded and the Start time
of the subsequent program are same:
If PROG. A is a DVD recording program, the
beginning of the PROG. B may be cut off.
• When the recording time of two programs
are overlapped, or the End time of a
program and the Start time of another
is the same, the first 30 seconds (at the
longest) of the subsequent program will be
cut off.
• If the cut-off portion comes up to one
minute or more, this program will be
displayed with error number E40 in the
timer programming list.
The priority of overlapped settings
PROG. A
PROG. B
Actual
recording
PROG. A
PROG. B
A programming set previously has priority
When the starting time is same:
A program set previously (PROG. A) has priority.
The first 30 seconds (at the longest) will be cut off.
PROG. A
PROG. B
Actual
recording
PROG. A
PROG. B
PROG. C
When some programming have been made at
the end time of the programming currently
being recorded:
A program set previously (PROG. B) has priority.
The first 30 seconds (at the longest) will be cut off.
PROG. A
PROG. B
Actual
recording
PROG.B PROG.A
When the recording time is partially overlapped:
PROG. A will start after PROG. B is complete to
be recorded.
The first 30 seconds (at the longest) will be cut off.
PROG. A
PROG. B
Actual
recording
PROG. B
When the recording time is entirely overlapped:
PROG.A will not be recorded.
• If there is a power failure or this unit has been unplugged for more than 30 seconds, the clock setting and
all timer programming will be lost.
• If a disc is not on the tray, the indicator flashes and Timer Recording cannot be performed. In some
cases, the indicator appears momentarily around the start point as the unit attempts to record. Please
insert a recordable disc.
• When all the Timer Recording is completed, the indicator flashes. To play or eject the recorded disc,
press
[POWER] first, and then press [PLAY B] or [OPEN/CLOSE A].
• During the Timer Recording or timer standby ( indicator is on the front panel display), any operations
on the unit will not be available. To make these operations available, cancel the Timer Recording or timer
standby first ( indicator disappears).
• To cancel the timer standby mode, press
[POWER].
• When the Start and the End time are the same, the length of the recording will be set for 24 hours. When
the disc reaches at the end during the recording, the unit turns itself off.
• When the programmed Start and End time are earlier than the current time, the setting will not be accepted
and be cleared for redoing.
• If the Start time is earlier and the End time is later than the current time, the recording will start right after
you turn the power off.
This unit records the programs according to priority if the timer programmings are overlapped. The timer
programming set previously has priority.
A Timer Recording of lower priority will be canceled, start from the middle or stop on the way.
Check the overlapped timer programmings and change the priority if necessary.
Timer Recording (cont’d)