Panasonic AJ-D92P VCR User Manual


 
27
Recording
How set to the users bit
By setting the user’s bit, a memo (time or date) or
other information using up to 8 hexadecimal digits can
be recorded on the sub-code track.
Concerning the users bit memory function
The user’s bit setting is automatically stored in the
memory and retained even when the unit’s power is
turned off.
<Note>
When TIME or DATE has been selected with the UB
MODE setting, the date or time which was set using
setup menu item No. 540 (TIME/DATE) is entered in
the user’s bit.
Set the DISPLAY switch to the UB position.
1
Set the TCG selector switch to the SET
position.
2
Select USER as the setup menu item No. 530
(UB MODE) setting.
3
Set the users bit using the SHIFT button as
well as the + and “–” buttons.
SHIFT button:
This causes the digit to be set to flash.
Each time it is pressed, the flashing digit
moves to the right.
+ button:
This increases the flashing digit by 1.
“–” button:
This decreases the flashing digit by 1.
4
O
A through F in hexadecimal notation are displayed as
shown in the table below.
1 2 4
O
When TIME is selected, the hours, minutes and
seconds are entered in the user’s bit.
O
When DATE is selected, the year, month, day and
hours are entered in the user’s bit.
Hexadecimal notation
Display
ABCDEF