Filter
Top Products
44
How to display the DIAG menu
Set the MENU switch to the ON position while
holding down the EJECT button.
The unit is set to the diagnosis display mode, and
“HOURS METER” appears on the video monitor.
1
Any item with “r” can be reset when servicing is
performed.
DIAG–MENU HOURS METER
Ser
H00 OPERATION 00000H
H01 DRUM RUN 00000H
H02 TAPE RUN 00000H
H03 THREADING 00000T
H11 DRUM RUN r 00000H
H12 TAPE RUN r 00000H
H13 THREADING r 00000T
END
While the hours meters screen is displayed,
press the MENU-UP button or MENU-DOWN
button while holding down the PAGE button.
The software version is displayed on the video
monitor.
2
When the MENU-UP button or MENU-DOWN
button is pressed again while holding down the
PAGE button, operation returns to the hours
meter display.
DIAG–MENU VERSION
<NTSC>
IF 1.
- - .
AV-SYSCON 1. - - .
DV 1. - - .
CYLINDER 1. - - .
REEL 1. - - .
END
Set the MENU switch to the OFF position.
Operation now returns to the normal mode.
3
This unit has a function for displaying an hours meter
and software version on the video monitor.
Setup (Initial Settings)