Panasonic AJ-D92P VCR User Manual


 
47
Setup Menus
131 LIGHT SET UP
0000
0001
OFF
ON
For setting whether LCD backlight illumination status is to be stored in the
memory when the power is switched off.
0: Status is not stored. When the power is turned back on, the backlight
illumination will always be off.
1: Status is stored.
132 26PIN REC
0000
0001
ALL
REC-P
OPERATION menu
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of setting
The underlining indicates the factory setting.
130 NO-VIDEO REC
0000
0001
OFF
ON
For setting whether to proceed with recording when no video signals are
input.
0: Recording is disabled. When the video signals are no longer input during
recording, operation is transferred to the REC PAUSE mode.
1: Recording is enabled.
For setting whether to acknowledge the REC command when the camera’s
START/STOP button is used for control while connection is made to the
CAMERA connector (26 pins).
0: The REC command is acknowledged regardless of the VTR mode.
1: The REC command is acknowledged only when the REC PAUSE mode
is established.
128 BATT WARNING
0000
0001
AUTO
MANUAL
For setting the voltage at which a warning is given when the battery is
nearly discharged.
0: The voltage is set by the battery which was set in setup menu item No.
113 (BATTERY SEL).
AU-BP402 : 11.4 V
BP-H90 : 11.0 V
BP-H100 : 11.6 V
HP-90 : 12.0 V
HP-90A : 11.4 V
1: The voltage setting can be changed to match the battery used. The
change made to the setting is saved.
Press the MODE button, and change the setting using the “00: BATT
NEAR END” menu.
129 BATT DISPLAY
0000
0001
OFF
ON
For setting whether to display the battery voltage on the status display
window when the METER button is pressed.
0: The voltage is not displayed in the status display window.
1: The voltage is displayed in the status display window.
O
Example of display shown: 11.2 V
00 BATT NEAR
END
10.7
14.0
10.7V
14.0V
For changing in 0.1 V increments the voltage setting at which a warning is
given when the battery is nearly discharged to match the battery used.
O
Initial voltage setting:
AU-BP402 : 11.2 V
BP-H90 : 10.9 V
BP-H100 : 11.6 V
HP-90 : 12.0 V
HP-90A : 11.4 V