Filter
Top Products
21
Setting the functions
Setting the speed at which to
move to the position set by the
preset memory
The speed at which to move to the position where the
remote camera has been set to be in the preset memory
when the preset operation is conducted can be set.
From the [SETUP] menu, select [PRESET] and display
[DIAG SPEED]. Then set the speed.
The higher the setting, the faster the operating speed.
1.DIAG SPEED ▼
1
Setting the operations to be
performed when a preset
operation is executed
The operations which the remote camera is to performed
when the preset operation is conducted can be set.
From the [SETUP] menu, select [PRESET] and display
[SCOPE]. Then set the operations to be performed.
2.SCOPE
MODE A
The operations that the camera performs when a preset
operation is executed differ depending on the mode
selected.
Mode Operations performed
MODE A Pan, tilt, zoom, focus, iris, gain, white balance
MODE B Pan, tilt, zoom, focus, iris
MODE C Pan, tilt, zoom
This function takes effect when the unit is connected to
the AW-HE50. It does not work with any other models.
Note
Returning the remote cameras
to their home position
The remote cameras connected can be returned to their
home position.
From the [SETUP] menu, select [PRESET] and display [HOME
POSITION]. Then press the F2 dial.
3.HOME POSITION▲
SET
Adjusting the panning, tilting,
zooming and focusing speed
The speed is adjusted uniformly for the panning, tilting,
zooming and focusing together.
When the PTZ/FOCUS SPEED dial is turned clockwise,
the speed is increased; conversely, when it is turned
counterclockwise, it is reduced.
PT ACTIVEAUTOIRIS
AUTO
HILOW
PTZ/FOCUS SPEED PAN/TILTFOCUS/PUSH OTAF
ZOOM
WIDE
CAMERA STATUS / SELECTION
12345
From the [SETUP] menu, select [OPERATE] and display
[SPEED TARGET]. If P/T is selected, the speed adjustment is
confined to panning and tilting only.
In this case, the zooming and focusing speed is fixed to the
speed which was set immediately before P/T was selected.