Filter
Top Products
38
Setup Software
The “Setup Software” is an application which enables the same functions as the unit’s automatic IP settings to be executed from
the host computer.
This is used to set the network environment for operating the remote camera using the host computer.
It can save the setting data files in the host computer, and it can load the saved files and reflect them in the network
environment.
For details, refer to the sections that follow.
When the settings are to be selected at the host computer using the “Setup Software”:
Do not perform the operation at the unit.
Do not start up the “Setup Software” in any other computer in the same network.
Do not use the “Easy IP Setup Software” which is provided with the AW-HE50.
Notes
Installing the software
This section describes how to install the Setup Software.
1. Insert the CD-ROM provided with the unit into the CD-ROM drive of the host computer in which the software application
is going to be installed.
2. Copy the entire folder containing “Setup Software” on the CD-ROM onto the hard disk drive of the host computer.
3. Double-click on “RP50Tool.exe” in the “Setup Software” folder which was copied to start Setup Software.
IP settings
On the “Setting” tab screen, set the IP addresses of the remote cameras and switcher.