Filter
Top Products
37
Basic Operation
The input mode changes each time this
button is pressed.
Video 1 Signal of source connected to INPUT 1 is displayed.
Video 2 Signal of source connected to INPUT 2 is displayed.
Video 3 Signal of source connected to INPUT 3 is displayed.
Comp 1 Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed.
Comp 2 Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed.
Comp 3 Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed.
RGB 1 Signal of source connected to RGB IN 1 is displayed.
RGB 2 Signal of source connected to RGB IN 2 is displayed.
HDMI Signal of source connected to HDMI IN is displayed.
TV
Video 1*
Video 2*
Video 3*
Comp 1*
HDMI*
RGB 2*
RGB 1*
Comp 3*
Comp 2*
Card input mode (Photo Viewer) is
selected.
The input source for picture signals can be changed by pressing TV/VIDEO, SD on the Remote
Control or CH up/down on the unit.
Changing the input signal
Device display operation
* If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 69.)
*
1
Changing input is only possible if
Cable/Antenna is set as the Input Set
setting.
Remote Control
Device display Unit
Antenna A
Antenna B*
1
TV
By pressing Channel Up/Down buttons
together, you can switch between TV
mode and an outside input source.
*
2
Input changes to the fi rst outside input
source of the Input Label not set to SKIP.
For example, if Video 1 is set to SKIP, input
is changed to Video 2. See the chart, below
(except for Photo mode).
Video 1*
2
Photo (Photo Viewer) Signal of source connected to CARD SLOT is displayed.
While Photo Viewer is displayed, the
channel or outside input source last
viewed is redisplayed.