Panasonic PT 60LCX63 Projection Television User Manual


 
8
For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: http://www.panasonic.com/contactinfo
Before Using
Emergency Alert System ( EAS) Forced Tuning
If a DCM (Digital Cable Module) is installed, the cable MSO (multiple system owner/operator) may provide
an Emergency Alert System message. These messages are intended to alert the general public of important
local or national emergency situations. In the event of receipt of one of these messages, the Device Display
shall immediately tune to the channel as directed by the EAS message. If the channel has been blocked
using the parental control, the parental blocking has priority over the forced tune.
Requires two AA batteries (supplied).
2. Install the batteries as shown in
the battery compartment.
(Polarity + or - must match the
markings in the compartment).
Two AA size
Remote Control Battery Installation
CAUTION
1. While pressing in on the catch,
open cover in direction of arrow.
3. Press cover in direction of
arrow until it snaps shut.
Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote
control.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
3. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
4. Battery replacement is necessary when the remote control acts sporadically or stops operating the Device
Display set.
Helpful Hints:
(1) For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life.
(2) Whenever you remove the batteries, you may need to reset the remote control infrared codes. We
rec om mend that you record the code on page 90, prior to setting up the remote.