Filter
Top Products
PROGRAMMING THE REMOTE CONTROl
Programming the Remote Control
The Universal Remote Control can be programmed to operate many manufacturers'
components using the component function buttons for VCR, DVD, AUX (RCVR, CD,
TAPE, CASSETTE DECK and LD), CBL, D'I-V, TV, or DBS. Follow the procedures for
programming your Remote Control with and without codes for the component.
Determine the manufacturer of the component and look in the table for the code.
Note: Be carefulto press ACTION in the middleof the button,ff you do not press in the
middle of the button,the arrow buttonsmay be activated. This will interruptyour
programming.
Programming With Code
• Confirm that the external component is plugged in and is turned on.
• Turn the component off.
• Press the ACTION and POWER button,together, for at least 5 seconds. All
mode buttons will flash, then let go ofthe buttons.
• Press appropriate component button (VCR, CBL, etc.) on the Remote
Control. The pressed button will illuminate steadily. All other buttons will go
out.
• Enter the 3-digit component code using the Remote Control numeric keypad
(0 ~ 9 buttons). If a proper code was entered, the mode button will blinktwice
and go out.
• Press the Remote Control POWER button to test the component. If the
procedure was successful, the component willturn on.
If the component does not operate with the Remote Control,
repeat the procedure using another code. (Some brands have
multiplecodes.)
If an incorrect code is entered, or ff the procedure takes longer
than 30 seconds, the programming willfail.
Programming Without Code
This procedure searches all codes and is called the "sequence method".
• Confirm that the external component is plugged in and is turned on.
• Turn the component off.
* Press the ACTION and POWER button, together, for at least 5 seconds. All
mode buttons will flash, then let go of the button.
• Press appropriate component button on the Remote Control. The pressed
button will illuminate. All other buttonswill go out.
• Press the D, button to move forward to the next code. Press the <1 button to
move backward.
• Press the Remote Control POWER button to test the component. If the
procedure was successful,the component willturn on.
Note: Repeat the preceding two steps until the component code is found. It may take many attempts
before the correct code is found.
• After the code is found, press the ACTION button to store the code.
[]