Filter
Top Products
40
GETTING STARTED
Step 9. Programming Available NTSC/ATSC Channels
YOU MUST PERFORM THE AUTOMATIC CHANNEL PROGRAMMING BEFORE
MANUALLY ADDING AND DELETING CHANNELS BECAUSE OF THE DIGITAL
TUNING SYSTEM USED BY THE HDTV Digital Receiver. THIS METHOD WILL
ENSURE THAT EVERY AVAILABLE CHANNEL IS CAPTURED AND STORED INTO
MEMORY.
Automatic Channel Programming
The HDTV Digital Receiver will scan for all available channels and store them in
memory. The scan will normally take several minutes to complete.
Procedure
H In SET UP Menu, select Ant Setup to choose AUTO Scan to automatically scan and store
all channels with a signal.
H Press the arrow to select AUTO.
H Press the ACTION button to start the auto scan.
H Press the ACTION button to cancel the auto scan or exit back to SET UP Menu after the
auto scan is complete.
H Press the arrow once to exit back to Roller Guide.
Note: As more digital channels become available in your area, the AUTO
feature must be selected to store the new digital channels into memory.
Manual Channel Programming
After programming all available channels, you can use the MANUAL feature to
selectively add or delete channels.
Procedure
H In SET UP Menu, select Ant Setup to choose Add/Del Ch to manually add or delete
channels.
H Press the to enter sub-menu.
• Use the , arrow buttons and numeric keypad to select a channel.
• Use the and arrow buttons to delete or add channels.
H Press the ACTION button to exit back to Ant Setup Menu.
H Press the arrow once to exit back to Setup Menu.
Automatic Channel Programming
The AUTO feature must be selected first to ensure that all
available channels are captured and stored into memory.