Filter
Top Products
C4631M (11/09) 29
PTZ MODE
The DX4104 supports up to four serial PTZ cameras. Multiple PTZ cameras can be connected and controlled individually by daisy-chaining the
camera connections. The unit also allows you to assign each camera a PTZ control address.
The DX4104 allows you to configure the following PTZ settings for each camera:
• Channel: Selects the channel (01 to 04) for PTZ configuration.
• Port: Sets the communication port for the camera: NONE, DATA1, or DATA2.
• Address: Sets the camera’s PTZ control address: 0 to 255.
• Protocol: Sets the PTZ protocol for all cameras on the port. Multiple cameras assigned to a port must use the same protocol. Table B lists
the supported device protocols.
• Baud Rate: Sets the baud rate for sending data to all cameras on the selected port: 1200, 2400, 4800, 9600, and 19200.
.
To set up the PTZ mode:
1. From the Camera menu, click PTZ.
2. Click the Channel box, and select the channel to configure.
3. Click the boxes to enter their settings.
4. Repeat step 2 and 3 to configure the other channels.
5. Click Close.
6. Click OK.
Table A. Supported PTZ Protocols
Protocol Name Pan/Tilt Zoom Focus Iris Preset Tour Setup
LG_MULTIX Yes Yes Yes Yes Yes Yes Yes
LG_SD168 Yes Yes Yes Yes Yes Yes Yes
PELCO_D Yes Yes Yes Yes Yes Yes Yes
PELCO_P Yes Yes Yes Yes Yes Yes Yes
GANZ_DSCP Yes Yes Yes Yes Yes Yes Yes
GANZ_P360V1 Yes Yes Yes Yes Yes Yes No
KALATEL_CYBERDOME Yes Yes Yes Yes Yes Yes No
PANASONIC_CS850 Yes Yes Yes Yes Yes Yes Yes
SAMSUNG_SCC Yes Yes Yes Yes Yes Yes Yes
BOSCH_AUTODOME Unsupported at this time.
LG_ZOOM No Yes Yes Yes No No Yes
LPT_A100L Yes No No No No No No