Filter
Top Products
10 C2258M (5/11)
7. Drill a “pilot hole” in the center of the upper right mark using a ¼" drill bit (not included) and power drill (not included) (Figure 7).
Only use a ¼" drill bit when drilling the pilot holes.
Figure 7. Drilling a Pilot Hole
8. Place the wall plate against the wall and align it with the pilot hole.
9. Insert one 5/16" x 3" lag bolt and one 5/16" washer into the upper right mounting hole and tighten using a socket wrench and ½" socket (not included)
(Figure 8).
Do not overtighten the lag bolt.
Figure 8. Inserting a Lag Bolt