19 C2258M (5/11)
UNIVERSAL WASHER INSTALLATION
The Universal Washers and Spacers are designed to accommodate the various M4, M5, M6 and M8 hole sizes required by flat-panels (Figure 27).
Do not place excessive pressure on the back of the flat-panel, as this may damage your flat-panel. The Universal Washer must also be installed
between the head of the mounting screw and the mounting bracket as shown (Figure 28).
Does your flat-panel have recessed mount points, uneven mount points, a curved back or any obstruction near the mount point?
• If Yes, you must install Universal Spacers. Remove the mounting brackets, Universal Washers, and mounting screws from the back of the flat-panel.
Proceed to the Universal Spacer Installation section on page 20.
• If No, skip to the Attaching the Mounting Bracket to the Flat-Panel section on page page 21.
Figure 27. Installing Universal Washers
M8
M5, M6
M4
Figure 28. Universal Washers and Spacers
Flat Panel
Universal Washer
Universal Spacer
Mounting Bracket
Mount Point
Mounting Screw
Mounting Screw
Universal Washer
Mounting Bracket
Flat-Panel
Universal Bracket
Mount Point