Filter
Top Products
16 C2258M (5/11)
4. Place the wall plate against the wall in the desired viewing location.
5. Adjust the wall plate to match the locations of the steel studs.
6. Level the wall plate.
7. Use a pencil (not included) and mark two upper and two lower locations where you will be drilling holes for the steel stud anchors (Figure 20).
8. Set the wall plate to one side in a safe location.
Figure 20. Marking Mounting Holes for Steel Stud Anchors
9. Use a power drill and 7/16" drill bit (not included) to drill a hole at each of the marks (Figure 21).
10. Insert a steel stud anchor into each hole.
If necessary, lightly tap each steel stud anchor into place with a hammer.
Figure 21. Drilling Mounting Holes for Steel Stud Anchors