24 C2258M (5/11)
Mounting Bracket Adjustments
If your flat-panel is tilted too far to one side, the leveling screws will allow you to compensate for this tilt by simply adjusting the screws with a
screwdriver.
1. Loosen both locking screws (Figure 35).
2. Adjust the tilt of your flat-panel.
3. Tighten both locking screws.
It is possible to dislodge your flat-panel while you level your flat-panel. Use extreme caution until you tighten the locking screws.
LEVELING SCREW ADJUSTMENT
M6 x 30 mm Leveling Screw
(1 per Bracket)
After you have finished leveling your flat-panel, be sure to tighten the two M6 x 35 mm locking screws (Figure 36).
Do not overtighten the locking screws.
LOCKING SCREW ADJUSTMENT
Figure 35. Adjusting the Leveling Screws
M6 x 35 mm Locking Screw
(1 per Bracket)
Figure 36. Adjusting the Locking Screws