Filter
Top Products
18 C2258M (5/11)
Installing the Mounting Bracket
1. Insert a small straw or toothpick into the threaded inserts found on the back of the flat-panel.
2. Use a pencil to mark the depth of the threaded insert on the small straw or toothpick.
3. Mark the straw or toothpick 1/8" above the depth of the threaded insert, as shown in Figure 24.
4. Insert the small straw or toothpick into the remaining threaded inserts to compare and verify their depth using the straw or toothpick’s 1/8" allowance
mark.
5. Locate the correct diameter screw for the threaded insert.
If the screw you selected is longer than the 1/8" allowance mark on the small straw or toothpick, as shown in Figure 25 and Figure 26, do not use
this screw. The screw length must not bypass the mark.
6. Test each size of the screws provided.
The correct screws should thread easily into the mounting point and not pull out when tension is applied.
Proceed to the Universal Washer Installation section on page 19.
25
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
24
26
Figure 24. Marking the Depth Above the Threaded Insert
Figure 25. Finding a Screw with the Correct Length
Figure 26. Finding a Screw with the Incorrect Length
SELECTING THE MOUNTING HARDWARE