Filter
Top Products
11 C2258M (5/11)
10. Level the wall plate.
11. Use a pencil (not included) to mark the remaining three mounting locations along the center of each wall stud (Figure 9).
Figure 9. Marking the Remaining Mounting Locations
Two people are recommended for this step; one person to level the wall plate and another person to drill the pilot holes.
12. Drill a “pilot hole” in the center of each of the marks with a power drill and a ¼" drill bit (Figure 10).
Only use a ¼" drill bit when drilling the pilot holes.
Figure 10. Drilling the Remaining Pilot Holes