13 C2258M (5/11)
Two people are recommended for this step; one person to level the wall plate and another person to mark the mounting locations.
1. Place the wall plate against the wall in the desired viewing location.
2. Level the wall plate.
3. Use a pencil (not included) and mark two upper and two lower mounting locations where you will be drilling holes for the concrete wedge anchors.
Each horizontal location cannot be closer than 12" apart (Figure 14).
4. Set the wall plate to one side in a safe location.
>12”
Figure 14. Placing the Wall Plate
5. Use a power drill (not included) and 5/16" concrete drill (not included) bit to drill a hole at each of the marks (Figure 15).
Figure 15. Drilling a Hole in Concrete