Philips 29PFL4908/F7 Flat Panel Television User Manual


 
19
English
9 Use ◄► to select your preferred energy efficiency level, then press
OK.
10 Use ◄► to select your preferred sound setting, then press OK.
11 Press OK to finish Settings assistant.
Network updates will appear after Connection test succeeds.
Use ◄► to select Ye s , then press OK.
When the initial setup is completed, the lowest memorized
channel with the confirmation message will be displayed on the
TV screen.
After an initial setup is completed...
If you want to scan the channels automatically again.
Autoprogram p.34
You can add the desired cable and Analog channels
unmemorized by AutoProgram.
Weak channel installation p.34
If you want to change to another language.
Language p.33
If you want to change the country setting.
Country p.45
If you want to change the location setting.
Location p.35
If you want to change the network setting.
Network p.37
If you want to restore the picture and sound setting.
Settings assistant p.27
Note
If you are not receiving a signal from your cable service, contact the Cable provider.
If you press during autoprogram, this setup of TV channels will be cancelled.
The initial AutoProgram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), select Autoprogram
again. p.34
Select the energy efficiency level you prefer.
Personal Energy saving
Select your preferred sound setting
Sound A Sound B Sound C
Store your preferences.
Cancel Store