Filter
Top Products
TV/VIDEO VCR DVD VCR Plus+
SUBTITLE AUDIO ANGLE ZOOM
DVD
SETUPMENU
DISC/VCR
DISPLAY
TIMER SET
BACK
PLAY
REW FFW
PREV NEXTPAUSE
REC STOP
OK
REPEAT
REPEAT
A-B
CH
+
-
CLEAR
REC MODE SEARCH MODE TITLE
English
16 First-time DVD/VCR Setup
3
Press K or L to select ENGLISH, FRANCAIS
(French) or ESPAÑOL (Spanish) as the language for
VCR On-Screen Displays and menus.Then, press B. The
display shown below will appear.
4
Press B to begin channel programming. AUTO SET
UP will flash on the TV screen during the Channel Search.
The DVD/VCR will memorize all available channels.When
channel programming is complete, the lowest available
channel will appear on the TV.
These channels will be available when you want to watch
TV while in VCR mode. To put the DVD/VCR in VCR
mode, press VCR so VCR light appears. Use CH + or CH -
to select memorized channels. To select non-memorized
channels, use the Number buttons.
•To skip this feature and play a
tape immediately,insert a tape
with its record tab removed.
• If you like to skip step 4, press
DISC/VCR MENU as soon as the
search begins.The DVD/VCR will
stop the Channel Search, and the
VCR menus and displays will be
in English.
• If you try to program channels
when there is no antenna or
Cable TV signal connected to the
ANT-IN jack of the DVD/VCR,
programming will stop. AUTO
SET UP will stop flashing.
Connect an antenna or Cable TV
signal to the DVD/VCR’s
ANT-IN jack and press B again.
• Repeat this process if the power
fails.
Helpful Hints
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
You cannot program channels if you are using a Cable Box or a
Satellite Receiver.
These menus may not appear if you have already turned
on the DVD/VCR.
1
Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel, depending on how you
connected the DVD/VCR to a TV.
2
Press VCR, then press y. VCR light will appear on the
front of the DVD/VCR. The display shown below will appear.
These menus may not appear if you have already turned on
the DVD/VCR. You may have turned on the DVD/VCR
before to find the Audio/Video In channel of the TV, for
example. If so, follow the steps on page 21 to set up
channels and page 23 to select a language for the VCR
menus.
1
Turn on the TV.
AUTO SET UP
PUSH B
2
3- 4
LANGUAGE SELECT
BENGLISH [ON]
FRANCAIS
ESPAÑOL
PUSH B
E8A21UD_EN1 5/29/06 3:13 PM Page 16