Filter
Top Products
23
Tips
Poor Picture •Have you selected the correct TV system in the manual installation menu?
• Is your monitor or house aerial located too close to loudspeakers, non-earthed
audio equipment or neon lights, etc.?
• Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of the
aerial.
• Is the picture or teletext unrecognisable? Check if you have entered the correct
frequency. See Installation, Manual installation, p. 6.
•Are brightness, sharpness and contrast out of adjustment? Select Factory
settings in the Setup, General menu, p. 8.
No Picture •Are the supplied cables connected properly ? (The aerial cable to the receiver
box, the other aerial to your recorder, the VGA cables to the display, the power
cables.)
• Has the child lock been switched off ?
• Is your PC switched on ?
• Do you see a black screen and the indicator in front of the monitor lights up
green, this means that the display mode is not supported. Switch your
VGA-source to a correct mode.
• In case of weak or bad signal, consult your dealer.
Digital distortion The low quality of some digital picture material may be the cause of digital image
distortion. In this case select the Soft setting using the Picture menu, Smart Picture,
without changing the picture settings manually.
No sound • No sound on any channel? Check the volume isn’t at minimum.
• Is the sound interrupted with the mute key ¬?
No Surround • Check if the headphone is not plugged in.
sound •Perhaps the channel is not broadcasting good quality surround sound.
• No sound from the rear speakers or the centre speakers? Select an appropriate
surround mode, according to the broadcasted sound signal or adjust the
volume. See Surround Modes, p. 12.
No solution found Switch your TV off and then on again once. Never attempt to repair a defective
for your picture or TV yourself. Check with your dealer or call a TV technician.
sound problem ?
Menu
Have you selected the wrong menu? Press the MENU key again to exit from the
menu.
NEX
TVIEW Orange indicator on front of the TV during standby / No NEXTVIEW info:
See Acquisition and updating of NEXTVIEW information, p. 16.
Displayed time is wrong:
The broadcaster on programme number one does not transmit the correct local
date and time. Use Reshuffle in the installation menu to place another broadcaster
on programme number one.
Remote control • Check if the remote control is in the correct mode.
• If your TV no longer responds to the remote control, the batteries may be dead.
•You can still use the
MENU key and the -/+ keys in front of the receiver
Tips
1029.2 en 25-03-2003 15:25 Pagina 23