Filter
Top Products
02
16
En
Specially shaped discs
Specially shaped discs (heart-shaped, hexagonal, etc.)
cannot be used on this player. Never use such discs, as
they will damage the player.
Condensation on discs
If the disc is moved suddenly from a cold place into a
warm room (in winter, for example), water droplets
(condensation) may form on the disc surface. Discs will
not play properly if there is condensation on them.
Carefully wipe off the water droplets from the disc surface
before using the disc.
Extended use of recording discs
Playing a specific section of a recording disc (BD-R/RE,
DVD-R/RW, etc.) continuously for extended periods of
time may reduce performance of the recorded surface
and make the disc unplayable. To avoid this, take
measures so that no single specific section is played for
extended periods of time, and replace the disc
periodically.
Installation Procedure
1 Disconnect all cords connected to the set
(including the power cord).
Before starting, check that there is no disc in the set.
2 Turn the set upside-down, and remove the
screws on the sides of the set.
Remove the 2 screws from each side.
Caution
• When mounting, be sure to place the set on a stable
surface, such as on a flat table, and raise the side of
the set on which you are mounting the rack mount
bracket by at least 10 mm.
Mounting the rack mount bracket without raising the
set at least 10 mm could damage the set.
• When mounting the rack mount bracket, be sure to
use the screws removed from the player. Using other
screws could damage the set or result in the set
falling.
3 Mount the rack mount brackets.
Mount the rack mount brackets to the screw holes in the
sides of the player using the screws removed from the
player in step 2 (two screws on each side).
•The rack mount brackets are d
if
ferent for the left (L)
and right (R) sides. Check the L and R marks on the
rack mount brackets and be sure to mount them on
the correct side.
• When mounting, first tighten the two screws removed
from the player to the extent that the rack mount
bracket moves when a gentle force is applied, check
that the rack mount bracket is properly attached, then
tighten the screws securely.
Screw holes
Rack mount bracket
Screws removed
from player
V6000_CUXJ_EN.book 16 ページ ２００９年６月５日 金曜日 午前１１時５７分