Filter
Top Products
09
72
En
Others
Problem Check Remedy
Player cannot be restored to
the factory defaults.
Is a disc loaded in the player? Remove the disc from the player before restoring the player to the
factory defaults (page 51).
Player cannot be controlled
by RS-232C.
Check the Advanced Setup Baud Rate setting and the serial
interface specifications (page 56 and 58).
The player’s power turns off
automatically.
Is Auto Power Off set to
On?
If Auto Power Off is set to On, the player’s power turns off
automatically if no operation is performed for over 30 minutes
(page 46).
Is Display Power Off set to
On?
The player’s power may turn off together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player’s
power to turn off when the TV’s power is turned off, set Display Power
Off to Off (page 44).
The player’s power turns on
automatically.
Is KURO LINK set to On?The player’s power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player’s
power to turn on when the TV’s power is turned on, set KURO LINK to
Off (page 44).
Player cannot be operated
with remote control.
Is an AV receiver or amplifier
connected to the CONTROL
IN terminal on the player’s
rear panel?
Operate with the remote control of the device connected to the
CONTROL IN terminal.
Are you operating the remote
control from a point too far
away from the player?
Operate from within 23 feet (7 m) of the remote control sensor.
Are the batteries dead? Replace the batteries (page 7).
Is the RC-232C Key Lock
command set?
Cancel the Key Lock command. For details, see the communications
interface user's manual.
Black screen is displayed
though no operations are
being performed.
Is Screen Saver set to On?
• The screensaver turns off when the player’s front panel or remote
control is operated.
• If you do not want the screensaver to be activated, set Screen Saver
to Off (page 46).
Front panel display does not
turn on.
Has the front panel display
been turned off?
Press FL DIMMER on the remote control to switch the front panel
display’s brightness (page 12).
Buttons on the player's front
panel cannot be operated or
the disc tray does not open.
Is Front Key Lock set to All
or Tray?
Set Front Key Lock to Off (page 55).
Input of connected TV and AV
system switches
automatically.
Is KURO LINK set to On?The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to the
player when playback starts on the player or the menu screen (Home
Media Gallery, etc.) is displayed. If you do not want the inputs of the
connected TV and AV system (AV receiver or amplifier, etc.) to switch
automatically, set KURO LINK to Off (page 44).
“Processing failed.” is
displayed.
If the message appears repeatedly, please ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Settings you have made have
been cleared.
• Have you disconnected the
power cord while the player’s
power was on?
• Has there been a power
failure?
Always press STANDBY/ON on the player’s front panel or
STANDBY/ON on the remote control and check that POWER OFF
has turned off from the player’s front panel display before
disconnecting the power cord. Be particularly careful when the power
cord is connected to the AC outlet on another device because the
player turns off in conjunction with the device.
V6000_CUXJ_EN.book 72 ページ ２００９年６月５日 金曜日 午前１１時５７分