Filter
Top Products
69
En
Use Other Equipment With Your Flat Panel TV
05
English
5 Use Other Equipment With Your Flat Panel
TV
Although earlier sections have mentioned other equipment for playing back video, this section provides control
and operation information for specific types of equipment.
5.1 Program the Remote Control to Operate Other Equipment
To operate other equipment or devices through your flat panel TV, program the panel’s remote control with the
equipment’s manufacturing code. A manufacturing code is a series of numbers that identify the type of device
and the brand. These codes are available in the section entitled “8.2 Manufacturer Codes to Program into the
Remote Control” in Appendix 8.2 of this manual.
5.1.1 Assign a Manufacturing Code to the Remote Control
To assign a preset Manufacturing code to the panel’s remote control,
follow the directions below. (For Manufacturing codes, refer to “8.2
Manufacturer Codes to Program into the Remote Control”)
1 ) Press SELECT to choose the device to program.
2 ) Press EDIT and 1 at the same time.
The selected mode indicator flashes when the remote control is
ready to be programmed.
3 ) Use the number buttons to enter a manufacturer code.
When the indicator turns off, the code has been programmed into
the remote control.
5.1.2 Issue a Library Search for a Manufacturer Code
If the code for a particular device is unknown, cycle through the available
codes for a similar unit then sample some functions for that code.
To find the code that properly operates the unit, follow the steps below
using different codes to find the best match.
1 ) Press SELECT to choose the device to program.
2 ) Press EDIT and 3 at the same time.
The selected mode indicator flashes when the remote control is
ready to search the code library.
3 ) Sample the code using a SOURCE POWER, PLAY, 1 or CH+
command.
4 ) Use the up/down arrow (/) buttons to advance to the next code
if the code fails to control the device.
Another option is to return to the previous code and repeat Step 3.
5 ) Press ENTER to lock in the code that properly operates the device.
All the available buttons for the selected mode are added when the
mode indicator flashes on for one second. The remote control then
returns to normal operation.
PDP6020FD.book Page 69 Monday, March 17, 2008 10:51 AM