Pioneer PDP-5020FD Flat Panel Television User Manual


 
78
En
05
Use Other Equipment With Your Flat Panel TV
To connect a device for HDMI Control, follow the steps below.
1 ) Turn on the flat panel TV and all other equipment.
2 ) Confirm that the panel’s Input Setting for HDMI Control Setting options comply with directions in the
operating instructions for the other device(s).
3 ) Confirm that the other equipment is set for HDMI Control.
4 ) Check that the audio and video are playing back properly from the equipment connected to the HDMI
terminal(s).
5 ) Turn Off the flat panel TV.
6 ) Pause for a few seconds before turning the power back on.
7 ) Verify that all equipment is functioning properly.
To select the device to control via HDMI Control, follow the steps below.
1 ) Access the
Option
through the
Setup
.
2 ) Select
HDMI Control Setting
from the Option menu.
3 ) Select
Input Setting
from the submenu.
4 ) Select the desired Input (INPUT 4, INPUT 5, INPUT 6, or INPUT 7).
5 ) Press HOME MENU to exit the menu.
If operating an HDMI supported device using an HDMI port other than the terminal selected in Input Setting, the
system malfunctions. When connecting to an HDMI terminal other than that selected in Input Setting, the
equipment settings should block HDMI Control functions. The HDMI Control menu is not selectable when the
option Input Setting under the HDMI Control Setting menu is set to Off.
The control menu changes to suit the type of HDMI-compatible equipment. When adding, changing, or removing
equipment from HDMI Control, refer to the sections below for installation notes and the supported commands.
5.3.1 Control an AV System
When adding an AV System, connect the unit between the panel and any recorders and/or players. To function
properly, an Audio/Video system should support the HDMI Control functions between the panel and any other
connected equipment.
If the AV system does not support HDMI Control but the other equipment (player/recorder) accepts this type of
control than connect the AV System through the panel’s DIGITAL OUT using an optical digital cable and AUDIO
OUT using an AV cable (commercially available). The other equipment connects to the HDMI port using an HDMI
compliant cable. Signals input from the HDMI are not output from DIGITAL OUT.
Power Off Test
Power On Test
Input Setting : INPUT 4
Power Off Control : On
Power-On Ready : On
Hold Sound Status : Off
PDP6020FD.book Page 78 Monday, March 17, 2008 10:51 AM