Filter
Top Products
Graphics contained within this publication are for representation only. 51
Chapter 6: Additional Information
Handling Cautions
• Before connecting other components to this DVD Recorder,be sure to turn all components off.
• Don’t move the player while a disc is being played.The disc may get scratched or broken,and the player’s internal parts may be damaged.
• Don’t put any container filled with liquid or any small metal objects on the DVD Recorder.
• Don’t put your hand into the disc tray.
• Don’t place anything other than the disc in the disc tray.
• Exterior influences such as lightning and static electricity can affect normal operation.If this occurs,turn the unit off and on again with the
STANDBY•ON button,or disconnect and then reconnect the AC power cord to the AC power outlet.The unit should operate normally.
• Be sure to remove the disc and turn off the player after use.
Maintenance of Cabinet
For safety reasons,when cleaning the cabinet be sure to disconnect the AC power cord from the AC outlet.
• Do not use benzene,thinner,or other solvents for cleaning.
• Wipe the cabinet with a soft cloth.
Formation of Condensation
• Due to sharp changes in temperature and humidity,condensation may form if warm air comes in contact with any cold parts inside the player.
• When condensation forms inside the player,the player may not operate correctly.If this occurs,leave the player at room temperature until the inside
of the player becomes dry and operational.
• If condensation forms on a disc,wipe the disc with a soft,dry cloth by moving the cloth from the center hole toward the outer edge.
Handling Discs
• Don’t touch the disc’s signal surfaces.Hold by the edges or by one edge and the hole in the center.
• Don’t affix labels or adhesive tape to label surfaces.Don’t scratch or damage the label.
• Do not use damaged (cracked or warped) discs.
Cleaning Discs
• Dirty discs can cause reduced video and audio performance.Always keep discs clean by wiping them gently with a soft cloth from the inner edge
toward the outer perimeter.
• If a disc becomes very dirty,wet a soft cloth in water,wring it out well.Wipe the dirt away gently,and remove any water drops with a dry cloth.
• Do not use record-cleaning sprays or anti-static agents on discs.Also,never clean the discs with benzene,thinner,or other volatile solvents which
may cause damage to the disc surface.
DRC8005N_part2.13004 2/2/04 6:32 PM Page 51