Filter
Top Products
Chapter 2 27
Using the Remote Control
INFO Brings up the Channel Banner with channel and viewing information.
Press again to remove the banner.
INPUT Toggles through the TV’s available input sources (INPUT 1, INPUT 2,
INPUT 3, INPUT 4, Front Input, HDMI/DVI, DTVLink and last-active channel).
To quickly access an input, press the INPUT button and the input number, for
example, INPUT + 1 to access INPUT 1.
LIGHT Press to illuminate the remote control’s buttons. To conserve battery
power, the light turns off after several seconds. Backlight won’t activate if
batteries are low, but blinks on and off quickly.
MENU Makes Main Menu appear and disappear.
Tips
The component button corresponding to the
mode you’re in flashes when the remote
batteries are low and you press a button on the
remote. A warning banner may also appear on
the screen when you press a remote button and
your batteries are low.
To turn off most RCA components that are
connected to the TV, press ON•OFF twice within
two seconds and hold remote steady until
indicator turns off.
MUTE Reduces the TV’s volume to its minimum level. Press again to restore volume. The TV Audio Output menu
must be set to Variable Level, Speakers On to control the TV’s volume.
OK When a menu item is highlighted, press OK to select the item.
ON•OFF Turns the TV on or off. Your HDTV is equipped with a special lamp system. In order to preserve the life
of the lamp, the TV must warm up and cool down properly when you turn the TV on and off. When you turn the TV
off, the screen turns blue and fades to black. While the screen is blue, you can still turn the TV back on. If the screen
is black when you try to turn it on, the TV’s lamp is in its cool-down cycle. The TV’s audio comes on, then the
picture is displayed after a few moments.
In other modes (VCR, DVD, SAT/CAB, AUX, AUDIO), and if programmed, turns the component on and off.
PIP Makes the PIP window appear and disappear (See Chapter 3 for more information about using PIP.)
PRESETS Toggles through the Picture Presets for the input currently tuned to. The preset is only temporarily
changed and goes back to the original menu setting when you change channels or inputs or turn off the TV.
REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE If programmed, provides transport control for some remote-
controllable VCRs and CD and DVD players. In TV mode, can control a DTVLink component when tuned to the
DTVLink input.
SAT/CAB (Satellite/Cable) Places the remote in SAT/CAB mode. If Auto Tuning is enabled, turns on the TV and
tunes it to the correct Video Input Channel.
SKIP Press once before changing channels and the TV returns to the original channel after 30 seconds. Press
repeatedly to add more time. Press CLEAR to cancel.
SOUND On digital channels/inputs, toggles the audio mode (if available for that channel). For analog channels,
toggles SAP on or off. If you change channels/inputs, the default for Audio Mode or SAP is restored. Does not affect
default menu settings for SAP or Audio Mode.
SWAP When using PIP, switches the main picture with the PIP window.
TV Places the remote in TV mode. Turns on the TV and tunes to the last-viewed TV channel or input.
VCR Places the remote in VCR mode. If Auto Tuning is enabled, turns on the TV and tunes to the VCR Video Input
Channel.
VOL – or VOL + Decreases or increases the TV’s volume. The TV Audio Output menu must be set to Variable
Level, Speakers On to control the TV’s volume.