Filter
Top Products
104
CHAPTER 7
Settings, preferences, upgrades, and extras
7
7
Setting RF Remote Control ID (Optional)
This set-up procedure only pertains to the optional Samsung RF remote.
You should set the ID number for your own RF code transmission to use the RF remote.
To set the RF remote control ID setup, follow these steps:
1
Press the MENU button on your remote control.
2
Highlight the Setup menu item, then press the SELECT button.
3
Highlight the Installation menu item, then press the SELECT
button.
4
Highlight the Remote Control Setup menu item, then press the
SELECT button. The Remote Control Setup menu appears.
5
Highlight the RF Remote Control ID menu item, then press the
SELECT button.
6
Input eight-digit serial number to enter into the RF remote
control ID menu as shown in the below figure.
The eight-digit serial number is displayed inside the battery
box of the RF remote control unit.
7
Input all of the eight-digit serial number displayed inside the
remote battery box using the numeric button or the arrow key.
Then, move the highlighted bar to the [Done] and press the
SELECT button.
8
Press the SELECT button to finish setting when the “Setting complete successfully” message
appears.
9
When you have finished setting the RF remote control ID screen, select the on-screen
Back button.
eight-digit serial number
†