Filter
Top Products
107
CHAPTER 8
Programming the remote control
8
8
4
Enter the three-digit code for your device (see the code lists on the following pages).
If the entered code is correct, the device will be turn off. If the brand number that you have
pressed is not correct, the device will not be turned off. Enter the three-digit code again (The
LED still lights up).
5
If the device is turned off, press the SET button again to save your brand number in the remote
control.
6
Repeat the procedure for other devices you wish to operate with your DIRECTV
®
HD Receiver’s
remote control.
Operating a device with your programmed remote control
To operate a device using your programmed remote control, you should turn on the LED
of the device using the MODE button. (TV, VCR, DVD, AUX, or DIRECTV).
Then use the remote control to operate that device. The remote control will continue to
operate that device until you press the MODE button twice. Each time you want to button
to a different device with your remote control, set the intended device using the MODE
button before starting.