Filter
Top Products
25
From the Technical
Information option
in the menu you
can access the
Version and
Software upgrade
menus.
Software Upgrade
allows you to
download the latest
software available
on the Engineering
channel which is
carried on Multiplex
1 (BBC).
Version/Software Upgrade/Common Interface
Note:
• During the Software
Updating process, do not
turn off the unit. At this time
you cannot use any of the
buttons, apart from
(STANDBY).
• After the Software
Updating process, the
Digital Menu memory
settings will be lost, so it is
necessary to go through
the setting up procedures
again.
Software upgrade
Version
Main menu Technical Information
A C
B
AC
B
Software upgrade
Version
Main menu Technical Information
A C
B
AC
B
Main menu Common Interface
A C
B
AC
B
Version
1
Press DIGITAL MENU, the menu will appear on
the screen.
Press B or A to select Technical Information option.
Press C or D to select ‘Version’ from the sub menu tab, then press ENTER.
Version information banner will appear.
Software Upgrade
1 Turn to a BBC channel first!
Select Technical Information option (the 5th icon
along at the top of the menu).
Select ‘Software upgrade’ from sub menu tab by pressing C or D. Then press
ENTER.
2
If a software upgrade is available from an Over-Air-Download (OAD) then the
message ‘S/W available, do you want to download?’ will be displayed - you
can then select ‘Yes’ or ‘No’ by pressing B or A, then press ENTER.
3
If you select the option ‘Yes’ then the Software Upgrade process will be initiated.
It will take about 20 minutes and after this process is complete, the TV will be
rebooted automatically.
If you select the option ‘No’ you can continue to watch TV programmes as
before.
Common Interface
1
Press DIGITAL MENU, the menu will appear on
the screen. Press B or A to select Common Interface option, then press ENTER.
2
The CAM module name will be displayed. You have to press ENTER to view
further information.
3
In the CI Menu, CAM specific information such as Module information, Smart
card information Language and Software Download are shown.
Press C or D to select information, then press ENTER to see detail.
4
Press EXIT to return to the normal screen.
Note:
• If you remove the CAM module in the digital TV mode then ‘CAM module has
been removed’ will be shown on the screen.
If you enter into the Common Interface menu when the CAM is not inserted
then ‘No CAM Found‘ will be displayed.
50A0201A_p24-25.p65 9/12/07, 4:57 PM25