Sansui TV19PL120DVD Flat Panel Television User Manual


 
50
Parental
Some discs are specified as not suitable for children. Such discs can be limited
not to playback with the unit.
1) Press or to select “Parental”, then press ENTER. “Enter Password” screen
will appear.
2) Press “0000” using Number buttons (0–9). (Please note, this is pre-setting
password of this unit). Then press ENTER. The parental level list
will appear.
Level 1: DVD software for adults cannot be played back.
Level 8:Virtually all DVD software can be played back.
Level Off: The parental control setting does not function.
3) Press or to select from the level 1 to level 8. The limitation will be more
severe as the level number is lower. Then press ENTER.
4) Press
to activate Parental control setting.
Note:
Depending on the discs, the unit cannot limit playback.
Some discs may not be encoded with specific rating level information though
its disc jacket says “adult.” For those discs, the age restriction will notwork.
The password is required every time when you change the parental level.
If you input a wrong number, press CANCEL.
Password
1) Press or to select “Password”, then press ENTER. “Enter Current
Password” screen will appear.
2) Press Number buttons (0–9) to input the current password (If the password
has not been set yet after you purchase this unit, it is “0000”).
3) Then press ENTER. “Enter New Password” screen will appear. Press
Number buttons (0–9) to input the new password.
4) Press ENTER. Now your new password has been set. Be sure to remember
this number!
If you forget the password.
1) Press
to remove the disc.
2) While holding 7 down on the remote control and at the same time press
STOP (DVD) on the top panel. “Password Clear” appears on the screen. Now
the password has been returned to the initial value (“0000”).
Customizing The Function Settings
Note:
If each setup (pages 48 ~
50) has been completed,
the unit can always work
under the same condition
(especially with DVD
discs).
Each setup will be retained
in the memory even if you
turn the power off.
50A0201A_p50-Back.p65 9/12/07, 5:00 PM50