Filter
Top Products
New Feature for Network Operations (Remote Setup)
9
You can use the RECORD settings menu to configure
recording conditions.
● Resolution (common to all channels)
Allows you to set the recorded video resolution.
This setting is applied to all the channels.
● Channel-specific Settings
These settings are specific to a particular channel.
1 Channel selector (CH1 - CH4)
2 Frame Rate
Allows you to set the frame rate at which to record the video
(NTSC: OFF/1 - 30f/s, PAL: OFF/1 - 25f/s).
3 Quality
Allows you to choose one of three quality levels: BASIC,
NORMAL, and FINE.
4 Recording
Allows you to set the recording mode.
• DISABLE: Disables recording.
• CONTINUOUS: Continuously records the video as long as
the DVR is on.
• BY MOTION:
Selecting this option causes the DVR to record the video
when its built-in motion sensor has detected a motion.
• BY EXT. SENSOR:
Selecting this option causes the DVR to record the video
when a sensor or similar device connected to the DVR’s
external sensor terminal is activated.
• BY SCHEDULE:
Selecting this option causes the DVR to record the video
during the scheduled time window.
5 Timer set
Set the operational schedule for timer recording (BY
SCHEDULE) using the [Schedule] screen. (For more
information on how to define the schedule, see Page 10.)
6 Motion Sensitivity
Allows you to set the motion sensor sensitivity (1 - 9).
The smaller the setting, the higher the sensitivity.
7 Sensor Type
Allows you to set the signal polarity of alarm input from an
external sensor.
• ----- :
Ignores alarm input.
• N/O (Normally Open):
Choose this option if the signal line is normally open and
gets closed when an alarm occurs.
• N/C (Normally Closed):
Choose this option if the signal line is normally closed and
gets opened when an alarm occurs.
8 Pre Record
Allows you to configure the pre-event recording feature.
When enabled, this feature always maintains the most recent
five frames while overwriting the previously saved frames; this
means that you can record the immediately preceding five
frames when an alarm event occurs.
• ON: Enables the pre-event recording feature.
• OFF: Disables the pre-event recording feature.
9 Alarm Duration
Allows you to set the duration of alarm signal output (1 - 60
SECONDS).
F Alarm
Allows you to choose whether to output an alarm signal in
response to an alarm event.
• ON: Enables the output of an alarm signal.
• OFF: Disables the output of an alarm signal.
G Audio
Allows you to enable or disable audio recording.
• ON: Records video with audio.
• OFF: Disables audio recording.
H Post Event Record
Allows you to set the post-event recording time (2 - 30
SECONDS, 1 - 5, 10, 15 MINUTES).
I Motion Zone
Allows you to set the motion sensor detection zone.
The "PARTIAL ZONE" option requires you to define the
detection zone. (For more information on how to define the
detection zone, see Page 10.)
• FULL ZONE: Detects a motion throughout the entire
screen.
• PARTIAL ZONE: Detects a motion within a user-defined
zone (area) only.
Record Settings (P27)
1
3
5
7
9
2
4
6
8
F
G
H
I