Filter
Top Products
New Feature for Network Operations (Remote Setup)
12
This is a submenu under the SYSTEM settings menu.
You can use this menu to check the DVR’s version and other
information.
• Version: Indicates the version of the firmware.
• Capacity: Indicates the capacity of the hard disk.
• IP Address
• MAC Address
This is a submenu under the SYSTEM settings menu.
When remotely controlling a PTZ camera connected to the
RS422/485 terminal, you can use this menu to configure the
communication settings.
1 Data Speed
Allows you to set the communication rate.
This setting is applied to all the channels.
2 Channel selector (CH1 - CH4)
3 Protocol
Allows you to specify which protocol to use in the specified
channel.
4 Address
Allows you to set the camera ID (0 - 63).
You can use this menu to configure the DVR’s network
information.
● Network Settings
1
Port
When multiple DVRs are connected to the network, you have
to configure the port number specific to each DVR.
2 Client Access
When you use network operations, make sure that this check
box is selected.
3 Band Width Saving
Select this check box when you want to save the network
bandwidth.
4 Address settings
Select the appropriate network type from the [Network Type]
drop-down list, and enter the necessary information, which
differs depending on your selected network type:
• If you select "LAN":
The fields require manual entries:
You have to enter the IP address, gateway, subnet mask,
and DNS server address.
• If you select "DHCP":
The fields do not require manual entries:
You do not have to enter anything.
• If you select "ADSL":
Enter your login ID and password.
Description (P29)
PTZ Control Settings (P11)
When multiple cameras are connected, use the same
protocol for all the cameras.
1
2
3
4
Network Settings (P33)
Changing the settings on this menu forcibly restarts the
DVR.
1
2 3
4