Filter
Top Products
New Feature for Network Operations (Remote Setup)
8
You can use the LIVE settings menu to configure live mode
settings such as how to monitor live videos.
● Common settings (General)
These settings are applied to all the channels.
1 OSD
Allows you to choose whether to display date/time and
channel number information on screen.
• ON: Displays the images from this channel.
• OFF: Does not display images from this channel.
2 Sequence
Allows you to enable or disable Camera Switch (Sequence)
mode, in which a single screen displays the available
channels one after another in the order of the channel
numbers.
• ON: Enables Camera Switch mode.
• OFF: Disables Camera Switch mode.
3 Seq-Dwell Time
Allows you to specify the interval (1 - 60 seconds) at which to
switch from one camera to another in Camera Switch mode.
4 Event Beep
Allows you to choose whether to generate an audible alarm
when an alarm event has occurred.
• ON: Enables the generation of an audible alarm.
• OFF: Disables the audible alarm.
5 Error Alarm
Allows you to choose whether to output an alarm signal when
the live video is disrupted or a hard disk error occurs.
• OFF:
Even if the live video is lost or if there is a hard disk error
no alarm is output.
• VIDEO LOSS:
An alarm is output when a live video loss occurs.
• HDD FAIL:
An alarm is output when a hard disk error occurs.
• ALL:
An alarm is output when both a live video loss and a hard
disk error occur.
6 VGA Screen Mode
Allows you to set how to display the software on a monitor
connected to the VGA port of the DVR.
• FULL: Displays the software in full screen mode.
• NORMAL: Displays the software with certain margins
around it.
7 OSD Contrast
Allows you to adjust the contrast of the text displayed on the
screen.
● Channel-specific Settings
These settings are specific to a particular channel.
1 Channel selector (CH1 - CH4)
2 Display
Allows you to choose whether to display images from this
channel on the monitor.
• ON: Displays the images from this channel.
• OFF: Does not display images from this channel.
3 Seq List:
Allows you to choose whether to display images from this
channel in Camera Switch (Sequence) mode.
• ON: Displays the images from this channel.
• OFF: Does not display images from this channel.
4 Display adjustment sliders
• Brightness: Allows you to adjust the brightness.
• Contrast: Allows you to adjust the contrast.
• Hue: Allows you to adjust the hue.
• Saturation: Allows you to adjust the saturation.
Live Settings (P25)
1 2
4
3
5
6
7
Changing this setting forcibly restarts the DVR.
1
2
3
4