Filter
Top Products
PREPARING FOR NETWORK CONTROL2
English 7
Whenever the button on the PC’s operation screen is
clicked, access will be cancelled and control rights will
switch back to the unit.
z To forcibly cancel PC access from the unit, press and
hold the [EXIT] button for at least 2 seconds.
z Access from the PC will not be permitted for a period of
10 seconds after access has been canceled.
z The access connection will also be cancelled whenever
communication with the PC is not possible for a period
of about 1 minute or more, and control rights will switch
back to the unit in such a case.
z If the browser is closed without clicking the button,
approximately one minute is required before
reconnection is possible.
Messages related to the switching of control or the network
connection condition may be displayed on-screen at any
time.
1 When control rights are switched to the
PC
“NETWORK CONTROL” appears on the monitor.
z The “NETWORK CONTROL” message is not displayed
when “NETWORK STATUS” has been set to “OFF”
using the unit’s menu. (Regardless of network
operations, the unit will continue to display images.)
2 When control rights are switched to the
unit
Whenever the button on the PC’s operation screen is
clicked, access will be cancelled and control rights will
switch back to the unit. In addition, the “NETWORK
CONTROL” message from the unit’s on-screen display will
be changed to “DISCONNECTED”.
z Once the message has changed to “DISCONNECTED”,
it can be cleared by pressing any of the unit’s buttons.
3 Forced disconnection from the unit
To forcibly cancel access by a PC, press and hold the
unit’s [EXIT] button for at least 2 seconds. When access is
forcibly cancelled in this way, the “NETWORK CONTROL”
message will be replaced with “DISCONNECTED”.
z Access from the PC will not be permitted for a period of
10 seconds after access has been canceled.
1 When disconnected from the network
2 When access cannot be made to a
connected DVR
3 When accessing a DVR that is already
connected to another 4 PCs
Controlling from the unit
Messages displayed when connected
Display on the unit
02
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
NETWORK CONTROL
NETWORK CONTROL
NETWORK CONTROL
Display on the PC
02
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
DISCONNECTED
DISCONNECTED
DISCONNECTED
e00_l8hbe_xe_nw_7.book Page 7 Monday, April 26, 2004 10:40 AM