Filter
Top Products
Sherbourn Technologies, Inc.
Owner’s Manual
9
Mde 950 7.1 Chae Pea/Pce
Owner’s Manual
Model PT-7000 Rear Panel
Below is a brief explanation of the connections and switches found on the rear
panel of the PT-7000 Preamp/Processor. Before connecting any audio or
video components to the unit, familiarize yourself with the type and location
of connectors available.
1 FM Antenna terminal (see page 20)
Use to connect the supplied FM antenna or an external 75 Ω antenna.
2 AM Antenna terminals (see page 20)
Connect the supplied AM loop antenna or an external AM antenna to
these terminals.
3 Remote Trigger jacks(see page 21)
Use the MAIN and ZONE DC TRIGGER jacks to control external devices
(such as a power amplier) with a 3-32 VDC trigger input. The device
connected to the MAIN jack will be activated when the PT-7000 is turned on
and should be used for connections to power ampliers for the main room
speakers. The device connected to the ZONE trigger will only be activated
when the Multizone system is turned on. Connect it to the amplier used
to power the speakers in the second zone.
4 Remote Control jacks (see page 21)
Use the MAIN and ZONE EXT REMOTE jacks to connect external IR sen-
sors to the PT-7000. When the unit is installed behind doors or where
it is not otherwise visible to the remote, connect an optional, external
sensor to the MAIN jack. To control the PT-7000’s Multiroom system from a
remote location, connect an optional remote sensor in the second room
to the ZONE jack
5 Component Video Input jacks (see page 19-20)
Use these two sets of jacks to connect devices with component video outputs
such as a DVD player or HDTV tuner.
6 S-Video jacks (see page 19-20)
Connect the S-Video output of sources to the appropriate input jacks.
Connect the VCR-OUT jack to the input of a VCR or other recorder and
connect the OUT jack to an S-Video input on your video display device.
7 Component Video Ouput jacks (see page 19-20)
Use these jacks to supply component video output to an external monitor
that accepts component video signals.
8 5.1 Channel Input jacks (see page 21)
Connect the multichannel signal from the analog audio outputs of a device
such as a DVD, DVD-A or SACD to these jacks.
9 Digital Outputs (see page 20)
Use the coaxial and optical digital outputs to connect the preamp/processor
to a device such as CD recorder, DAT recorder, or other similar device that
accepts a digital audio input.
Model PT-7000 Rear Panel