Filter
Top Products
Editing
41
EN
You can synchronize starting and pausing of recording on this VCR
(recorder) and starting and pausing of playback on the other VCR
(player).
You need a player VCR equipped with a LANC jack for this editing.
Connect the LANC jack on this VCR to that on the other VCR, using the
LANC cable.
1 Locate the points where you want to start playback or
recording. Then, set this VCR and the other VCR to
playback pause mode.
2 Press EDIT STANDBY.
3 Press START/PAUSE.
Playback starts on the other VCR and recording starts on this
VCR.
4 Press START/PAUSE the point you want to stop editing.
Both VCRs are set to pause.
If the tape passes the point to stop editing, press RECORDER and
rewind the tape to that point, with the shuttle ring or jog dial.
5 To edit another scene, repeat steps 1 to 4.
6 To finish editing, press EDIT STANDBY.
Both VCRs stop.
Synchronized editing
Notes
• The recording does not
stop the moment you press
p to stop editing. The
source picture may be
recorded a little longer than
you expect.
• If you record on the
beginning part of the tape,
or on the part just after an
unrecorded portion, the
first part of the recording
may be dropped.
• When you record on a new
or fully rewound tape, do a
trial recording for about 15
seconds, then start the
actual recording. If you
start the actual recording
from the beginning of the
tape, the first part may not
be recorded when you play
back the tape on another
VCR.