Filter
Top Products
Editing
50
EN
Connecting other
equipment
For usage, connections, etc., refer to the instruction manual of the
equipment to be connected.
Connecting an editing controller
• When using this VCR as a recorder or as a player, set the LANC
MODE on this VCR to “S.”
• If the controller has a shuttle mode, set it to “B.”
• When you edit tapes using video/audio code and connecting an
editing controller RM-E1000T to this VCR (recorder), set the
“SEARCH” in the menu of RM-E1000T to “FF/REW.”
Connecting a titler and a digital SEG
• When using this VCR as a player, set “AUTO DISPLAY” on the SET
UP MENU to “OFF.”
• When connecting a titler and a digital SEG equipped with the S
VIDEO jack, use the S VIDEO connection.
Connecting a still picture capture board kit
• Set the LANC MODE on this VCR to “S.”
Connecting a Video Printer equipped with a LANC
jack.
• Set the LANC MODE on this VCR to “S.”
Making a tape duplication system by connecting a
number of DSR-30/30P units
• Make sure to use an audio/video distributor. If you make a loop
connection, picture and sound may deteriorate.
• When using a CONTROL S jack, you can make a loop-through
connection. Check the commander mode of the wired remote
commander and set the same mode on this VCR. (page 17)
• For details on a wired remote commander, consult the shop where
you purchased it.
You cannot use the following remote commanders with this VCR:
SVRM-100, RM-250, RM-S18 and RM-S52A.