Filter
Top Products
5-3 Basic Menu
Chapter 5 Setup Menu
5-8 Chapter 5 Setup Menu
Item number Item name Settings
013
SYSTEM FREQUENCY
SELECT
Specifies whether to enable switching the system frequencies.
OFF : Do not enable system switching.
ON: Enable system switching.
You can switch the system frequencies of this unit between 29.97, 25, 24
(J-H3 only), 23.98 (J-H3 only) and 23.98PD (J-H3 only).
For information on how to switch the system or other details, see “Switching
system frequency (menu item 013)” on page 5-4.
020 DROP-FRAME MODE
SELECT
(J-H1:29.97 system only)
(J-H3: 29.97/23.98PD
system only)
Determines the drop-frame mode of the CTL counter.
DF : Drop-frame mode
NDF: Non-drop-frame mode
Note
When the unit operates in the 23.98PD system, the setting of this item
determines the advancement mode (DF/NDF) of the output time code.
022
PF2 KEY SELECT
Determines the function assigned to the PF2 button.
REM : Displays the remaining tape time in minutes.
RUN : Displays the total number of times that the tape has been running up until
that time.
024
MENU CHARACTER
TYPE
Selects the type of characters to superimpose on the video signal (overlaid
display) output from the VIDEO OUTPUT connectors.
WHITE : White letters on a black background
BLACK: Black letters on a white background
W/OUT: White letters with black outlines
B/OUT: Black letters with white outlines
026
AUDIO MONITOR MODE
Select a mode of AUDIO MONITOR.
MONO: Monaural
STEREO : Stereo + mix
All: Monaural + stereo + mix
027
SD CHARACTER
(J-H3: 29.97/25/23.98PD
system only)
Select whether or not to superimpose the type of characters on the video signal
(overlap display) output from the SD (D CONV.) connectors.
Setting for the J-H1
OFF: Does not superimpose.
ON : Superimposes.
Setting for the J-H3
OFF: Does not superimpose on any of the SD output.
COMPOSITE: Superimposes on the COMPOSITE (SUPER) connector output
only.
SDI: Superimposes on the SDI (SUPER) connector output only.
ALL : Superimposes on all the SD output.
028 HD CHARACTER Selects whether or not to superimpose characters on the video signal (overlap
display) output from the HD connectors.
Setting for the J-H1
OFF: Does not superimpose.
ON : Superimposes.
Setting for the J-H3
OFF: Does not superimpose on any of the HD output.
ANALOG: Superimposes on the COMPONENT/D3/MONITOR connectors output
only.
SDI: Superimposes on the HD SDI (SUPER) connector output only.
ALL : Superimposes on all the HD output.
030
I.LINK CHARACTER
(available only with the
HKJ-101 i.LINK Interface
Board)
(J-H3: 29.97/25/23.98PD
system only)
Selects whether or not to superimpose characters on the video signal (overlap
display) output from the
DV connector.
OFF : Does not superimpose.
ON: Superimposes.