Sony KDL-32L4010 Flat Panel Television User Manual


 
16
3. Connecting the TV
Cable or VHF/UHF (or VHF only)
~
It is recommended that you connect the antenna/cable input using a 75-ohm coaxial cable (not supplied) to
receive optimum picture quality. A 300 ohm twin lead cable can be easily affected by radio frequency
interference, resulting in signal degradation.
Cable and VHF/UHF (or VHF only)
If you want to watch both cable and antenna (over-the-air) programming, you will need to use an
optional A-B RF Switch (not supplied) to switch between the cable and over-the-air antenna
programming, as shown.
You can also enjoy high-definition programming by subscribing to high-definition cable service or high-
definition satellite service. For the best possible picture, connect these components to your TV via the
HDMI or component video (with audio) input on the back of your TV.
Cable system and/or VHF/UHF
~
• Be sure to set Cable On or Off in the Channel menu for the type of input signal you choose
(see page 34).
HD cable box/HD satellite box
75-ohm coaxial cable
(not supplied)
Rear of TV
CABLE/ANTENNA input
B
A
A-B RF (Radio
frequency) Switch
Rear of TV
CABLE/ANTENNA input
Cable
Antenna
VIDEO IN PC IN
COMPONENT IN
(1080i/720p/480p/480i)
RL
AUDIO
AUDIO OUT
(FIX)
21
1
1
2
CABLE / ANTENNA
VIDEO
AUDIO
AUDIO
AUDIO
(MONO)
L
R
S VIDEO
SERVICE
ONLY
Y
P
B
P
R
L
R
LR
RGB
DIGITAL
AUDIO
OUT
(COAXIAL)
IN
HD cable box/
HD satellite box
Rear of TV
HDMI cable
Shown with HDMI Connection
CATV/Satellite
antenna cable