Filter
Top Products
Getting Started
9
You can bundle the connecting cables as
illustrated below.
1 Get the cable holder from the accessories
bag and place the screw (supplied) in the
cable holder without exerting pressure.
2
Install the cable holder on the Table-Top
Stand by exerting pressure on the screw and
turning it to the left.
3 Secure the connection cables as illustrated
below.
~
• Do not bundle the AC power cord with other
connecting cables.
This TV can be installed on a wall by using a
Wall-Mount Bracket (sold separately). Before
mounting the TV on a wall, the Table-Top
Stand must be removed from the TV.
~
• Do not remove the Table-Top Stand for any reason
other than to wall-mount the TV.
• For product protection and safety reasons,
Sony strongly recommends you use the Wall-
Mount Bracket model designed for your TV
and the wall-mounting of your TV should be
performed by a Sony dealer or licensed
contractor.
Use your TV with the following wall-mount
bracket only.
~
• For bracket installation, refer to the instructions on
page 10 and the instruction guide provided by the
Wall-Mount Bracket model for your TV. Sufficient
expertise is required to install this TV, especially to
determine the strength of the wall that will
withstand the TV’s weight.
• Be sure to store the removed screws and Table-Top
Stand in a safe place until you are ready to reattach
the Table-Top Stand. Keep the screws away from
children.
• Be sure to use the screws supplied with the Wall-
Mount Bracket when attaching the mounting
hooks to the TV set.
Supplied screws are designed so they are between
8 to 12 mm in length when measured from the
attaching surface of the mounting hook. The
diameter and length of the screws differ depending
on the Wall-Mount Bracket model. Use of screws
other than those supplied may result in internal
damage to the TV set or cause it to fall.
Bundling the Connecting Cables Preparation for Wall-Mounting
Sony TV Model No.
KDL-32L4010
Sony Wall-Mount Bracket
Model No.
SU-WL500
Screw
(supplied with the
Wall-Mount Bracket)
8-12 mm
Rear of TV
Mounting Hook
(Continued)