Filter
Top Products
Location and Function of Parts and Controls
15
ENTER button
Press to confirm a selected item on the menu.
i POWER switch and indicator
Press to turn on the power. The indicator lights in green.
Press again to turn off the power.
The indicator lights in amber in power saving mode.
j Stand
You can set the monitor display in 90 degrees by using the
stand
(see “Using the stand” on page 15).
k Speaker
The audio signal which is selected by the input select
button on the front panel is output.
When the headphones are inserted, the sound is not
output.
l LINE A button
Press to monitor the signal through the LINE A input
connectors.
m LINE B button
Press to monitor the signal through the LINE B input
connectors.
n RGB/COMPONENT button
Press to monitor the signal through the RGB/
COMPONENT input connectors.
o SDI-1 button (for LMD-9050/9030)
Press to monitor the signal from the SDI IN-1 connector.
p SDI-2 button (for LMD-9050/9030)
Press to monitor the signal from the SDI IN-2 connector.
q EXT SYNC (external sync) button
Press to operate the unit on an external sync signal
through the EXT SYNC IN connector.
The EXT SYNC button works when the component/
RGB signals are input.
r SCAN select button
You can change the scan size of the picture. When you
press the button, the scan size is changed to the normal
scan (5% over scan), -3% under scan or zero scan or
zoom set on the menu (see page 27).
s ASPECT select button
Sets the aspect ratio of the picture, 4:3 or 16:9.
t MARKER button
When the button is pressed, an area marker is displayed.
u BLUE ONLY button
Press this button to eliminate the red and green signals.
Only blue signal is displayed on the screen. This
facilitates “chroma” and “phase” adjustments and
observation of VCR noise.
v MONO button
Press this button to display a monochrome picture.
When the button is pressed again, the monitor switches
automatically to color mode.
w KEY INHIBIT indicator
When the key inhibit function works, the indicator
lights.
For the key inhibit function, refer to “KEY INHIBIT
menu” on page 29.
Using the stand
11.5˚
Pull out toward rear side.