Filter
Top Products
Selecting the Default Settings
21
1
Press the POWER switch.
The power is turned on and the SELECT SETTING
screen appears.
2
Press the M or m button to select the area where you
intend to use the unit and press the , or ENTER
button.
If you select either LATIN AMERICA or ASIA
EXCEPT JAPAN, one of the following screens
appears.
2 If LATIN AMERICA is selected:
4 If ASIA EXCEPT JAPAN is selected:
Customers who will use this unit in the shaded
areas shown in the map below should select NTSC
AREA.
Other customers should select PAL AREA.
3
Press the M or m button to narrow the area further
and then press the , or ENTER button.
The SELECT SETTING screen disappears and the
menu item settings suitable for the selected area are
applied.
Note
When you have selected the wrong area, set the
following items using the menu.
COLOR TEMP (on page 25)
COMP LEVEL(on page 26)
NTSC SETUP (on page 26)
See “The default setting values for each area” (on
page 20) on the setting value.
APERTURE
LINE A LINE B
RGB/
COMPONENT
SDI-1 SDI-2 SCAN ASPECT MARKER MONO
ENTER
KEY INHIBIT
RESET MENU
POWER
BLUE
ONLY
EXT
SYNC
BRIGHT CHROMA PHASE CONTRAST VOLUME
APERTURE
LINE A LINE B
RGB/
COMPONENT
SCAN ASPECT MARKER MONO
ENTER
KEY INHIBIT
RESET MENU
POWER
BLUE
ONLY
EXT
SYNC
BRIGHT CHROMA PHASE CONTRAST VOLUME
12~3
12~3
LMD-9050/9030
LMD-9020
S E L E C T S E T T I N G
x N O R T H A M E R I C A
• L A T I N A M E R I C A
• A F R I C A A U S T R A L A S I A
E U R O P E M I D D L E - E A S T
• A S I A E X C E P T J A P A N
• J A P A N
1North America
2Latin America
3Africa Australia/New
Zealand, Europe, Middle
East, Russia
4Asia Except Japan
5Japan
L A T I N A M E R I C A
x P A L & P A L - N A R E A
A R G E N T I N A
P A R A G U A Y
U R U G U A Y
• N T S C & P A L - M A R E A
O T H E R A R E A
PAL&PAL-N area
Argentina
Paraguay
Uruguay
NTSC&PAL-M area
Other area
A S I A E X C E P T J A P A N
x N T S C A R E A
• P A L A R E A
NTSC area
PAL area