Filter
Top Products
Adjustment Using the Menus
26
USER CONFIG menu
You can select a language, etc.
Submenu Setting
SUB CONTROL The adjustment range of the CONTRAST,
BRIGHT, CHROMA and PHASE controls
is adjusted precisely.
• CONTRAST: Adjusts the picture
contrast.
• BRIGHT: Adjusts the picture
brightness.
• CHROMA: Adjusts color intensity.
The higher the setting, the greater
the intensity. The lower the setting,
the lower the intensity.
• PHASE: Adjusts color tones. The
higher the setting, the more
greenish the picture. The lower the
setting, the more purplish the
picture.
For details of input signals and adjustable/
setting items, see page 16.
PICTURE
CONTROL
You can adjust the picture.
• V SHARPNESS: A crisp image can be
displayed. When the setting is
higher, the picture becomes even
more crisp.
x RGB/COMP SEL xxxx
· MATRIX xxx
· COMP LEVEL xxxxx
· NTSC SETUP x
· GAMMA x
· FORMAT DISP xxx
· LANGUAGE xxx
· SDI AUDIO xxxxxxx
USER CONFIG (1/2) Rr
xPOWER SAVING xx
· MARKER xxx
· CENTER MARKER xxx
· MARKER LEVEL x
· MARKER MAT xxx
· MARKER LINE xxxx
· SCAN xxxx
USER CONFIG (2/2) Rr
Note
The USER CONFIG menu “SDI AUDIO” is not
displayed in LMD-9020.
Submenu Setting
RGB/COMP SEL When a signal input via the RGB/
COMPONENT connector is being
monitored, based on the signal
being input, select RGB or COMP.
MATRIX Applied to 480/60I or 480/60P
signal. Select 601 or 709.
COMP LEVEL Select the component level from
among three modes.
• SMPTE for 100/0/100/0 signal
• BETA 0 for 100/0/75/0 signal
• BETA 7.5 for 100/7.5/75/7.5
signal
NTSC SETUP Select the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
GAMMA Selects the appropriate gamma
mode. You can select from among
5 settings. When “3” is selected,
the setting is roughly same as the
gamma mode of the CRT (2.2).
FORMAT DISP Select the display mode of the
signal format.
• ON: The mode is always
displayed.
• OFF: The display is hidden.
• AUTO: The format is displayed
for about 10 seconds when
the input of the signal
begins.
LANGUAGE You can select the menu or message
language from among seven
languages.
• ENGLISH: English
• DEUTSCH: German
• FRANÇAIS: French
• ITALIANO: Italian
• ESPAÑOL: Spanish
• : Japanese
• : Chinese
SDI AUDIO
(for LMD-9050/9030)
Selects an SDI audio channel.
CH1, CH2, CH3, CH4, CH5, CH6,
CH7, CH8, CH9, CH10, CH11,
CH12, CH13, CH14, CH15, CH16,
OFF
POWER SAVING Sets the power saving mode on or
off. When set to ON, the monitor
goes into power saving mode if no
signal is input for about one minute.