Filter
Top Products
19
Hookups and Settings
By using the PROGRESSIVE button, you can
select the signal format in which the recorder
outputs video signals: interlace or progressive.
1 Connect the recorder using the
COMPONENT VIDEO OUT jacks (pattern
D on page 16).
2 Set “Component Out” in “Video” setup to
“On” (page 95).
3 Press the PROGRESSIVE button.
“PROGRESSIVE” appears in the front panel
display when the recorder outputs progressive
signals.
◆ Progressive
Select this when:
–your TV accepts progressive signals, and,
–the TV is connected to the COMPONENT
VIDEO OUT jacks.
Note that the pictures will not be clear or no
picture will appear if you select progressive signal
output when either of the above conditions is not
met.
◆ Interlace
Set to this position when:
–your TV does not accept progressive signals, or,
–your TV is connected to jacks other than the
COMPONENT VIDEO OUT jacks (LINE 2
OUT (VIDEO or S VIDEO)).
z Hint
When you select progressive signal output, you can fine-
tune the signal according to the type of software you are
watching (page 95).
Using the PROGRESSIVE button