Filter
Top Products
Other Information
113
Other Information
General
Problem Possible Remedies
How to restore Video settings
to factory settings
❏ Press RESET on the remote control while in the Video Menu (see page 88).
How to restore Audio settings
to factory settings
❏ Press RESET on the remote control while in the Audio Menu (see page 92).
Cannot cycle through the other
video equipment connected to
the LCD projection TV
❏ Be sure the Video Label option is not set to Skip (see page 103).
Cannot operate Menu ❏ If a menu option appears in gray, this indicates that the menu option is not
available.
Lost password ❏ In the password screen (see page 98), enter the following master password: 4357.
The master password clears your previous password; it cannot be used to
temporarily unblock channels.
❏ The i.LINK STANDBY LED blinks when the signal from an i.LINK device is
being shown.
The signal from a selected
i.LINK device is not being
displayed
❏ If you have several i.LINK devices connected and operating at once, the LCD
projection TV may not be able to display the signal from the selected device. Turn
the other i.LINK devices off, and reselect the desired i.LINK device.