Filter
Top Products
Installing and Connecting the LCD Projection TV
30
Cable Box Only For best results, use this connection if:
❑
Your cable company scrambles all channels, which requires you to use a
cable box.
❑ You do not have a VCR. (If you have a VCR, see pages 32 and 33.)
With this connection you can:
❑
Use the LCD projection TV remote control to change channels coming
through the cable box to the LCD projection TV’s VHF/UHF jack. (You
must first program the remote control for your specific cable box.)
To connect the cable box
1 Connect the CATV cable to the cable box’s input jack.
2 Use a coaxial cable to connect the cable box’s output jack to the LCD
projection TV’s VHF/UHF jack.
3 Run the Auto Setup program, as described in “Setting Up the LCD
Projection TV Automatically” on page 45.
Notes on Using This Connection
About Using This Connection with Dual Picture (Twin View, etc.)
Features
With this connection, all channels come into the LCD projection TV through your
cable box and only one unscrambled signal is sent to the LCD projection TV, so you
cannot use the dual picture features. If some of your channels are scrambled, but
others are not, consider using the “Cable Box and Cable Only” connection on page
28 instead.
To do this... Do This ...
Use the cable box Tune the LCD projection TV to the channel the cable box
is set to (usually channel 3 or 4) and then use the cable box
to switch channels.
Set up the LCD
projection TV remote
control to operate the
cable box
Program the remote control. See “Programming the
Remote Control” on pages 48.
VHF/UHF
CATV cable
Coaxial cable
Rear of LCD projection TV
Cable box
OUT
IN