Filter
Top Products
D:\DVR project\Instruction
manual\DTP\2689634111\GB12ADJ-CEK.fm
master page=left
SVR-S500
2-689-634-11(1)
44
Subtitle Language
Selects your preferred subtitle language.
Press the </, buttons to set the desired
language. Each time you press the buttons, the
setting on the TV screen changes as follows.
b Note
• If the programme broadcast carries the optional subtitle
language you have chosen, subtitles will be viewed in
that language. Otherwise, you will only be able to view
in the default language.
Interactivity
Interactive services are currently available on
some channels. See page 23.
If you do not wish to operate interactive services
through your receiver, press the </, buttons to
turn this function off.
Sleep Timer
Sets the Hard Disk Recorder to turn itself off.
Press the </, buttons to adjust the settings in 5
minute periods (up to 2 hours).
b Notes
• To cancel the Sleep Timer, reset the value to “0”.
• Once Sleep Timer is set, a warning message will be
displayed in the last 30 seconds before the Hard Disk
Recorder shuts down to allow you to cancel.
• The Sleep Timer may also turn off your TV if it is
directly connected to the Hard Disk Recorder via
SCART.
Front Panel
Adjusts the lighting of the front panel display.
Command Mode
Changes the Command Mode of the recorder if
another Sony Hard Disk recorder is assigned the
same Command Mode. Be sure to match the
Command Mode on the remote to the setting made
here. For details, see “If you have more than one
Sony Hard Disk Recorder” on page 12.
Format HDD
Deletes all saved programming on your Hard Disk
recorder. Note that all of your previous channel
listing, favourite channels, recordings and timer
settings will be erased.
1 Select “Format HDD” in “Features,” and
press ENTER
The display for entering the Personal
Identification Number (PIN) appears.
2 Enter your four-digit password using the
number buttons and press ENTER.
3 Once the warning message display appears,
press ENTER again to format the Hard Disk.
4 The recorder reboots automatically after a few
seconds to complete HDD format.
Follow the on-screen instructions to enable
the recorder to start searching for all of the
receivable TV and Radio channels in your
local area. See “Step 6: Auto Tuning (Full
Channel Scan)” on page 13.
b Note
If you forget your password, you will have to reset it by
selecting “Parental Lock” in “DTV Settings” setup
(page 40).
Factory Setup
Allows you return all the settings to their default
position and to keep your channel listing,
favourite channels and all recordings stored on the
hard disk. Note that all of your previous settings
will be lost.
1 Select “Factory Setup” in “Features,” and
press ENTER
The display for entering the Personal
Identification Number (PIN) appears.
2 Enter your four-digit password using the
number buttons and press ENTER.
On Allows you to operate interactive
services (when available).
Off Turns off the access
to interactive
services on a permanent basis
.
On
Bright lighting.
Dimmed Low lighting.
Off Turns off the lighting.
English
Unknown
Welsh
Gaelic
HDD 1 The default Command Mode of
the recorder.
HDD 2 Select this if the default Command
Mode conflicts with other Sony
Hard Disk recorders.
HDD 3 Select this if the default Command
Mode conflicts with other Sony
Hard Disk recorders.